Arduino LCD Display Control

The LCDs have a parallel interface, meaning that the microcontroller has to manipulate several interface pins at once to control the display. The interface consists of the following pins:

  • A register select (RS) pin that controls where in the LCD’s memory you’re writing data to. You can select either the data register, which holds what goes on the screen, or an instruction register, which is where the LCD’s controller looks for instructions on what to do next.
  • A Read/Write (R/W) pin that selects reading mode or writing mode
  • An Enable pin that enables writing to the registers
  • 8 data pins (D0 -D7). The states of these pins (high or low) are the bits that you’re writing to a register when you write, or the values you’re reading when you read.
  • There’s also a display constrast pin (Vo), power supply pins (+5V and Gnd) and LED Backlight (Bklt+ and BKlt-) pins that you can use to power the LCD, control the display contrast, and turn on and off the LED backlight, respectively.

Hardware Required

  • Arduino Board
  • LCD Screen
  • Pin headers
  • 10k ohm potentiometer
  • 220 ohm resistor
  • Jumper wires
  • Breadboard

Arduino Compatible SCM & DIY Kits
Electronics Equipments & Tools
Module Board For Arduino

51,015 views
301   

Circuit

Before wiring the LCD screen to your Arduino or Genuino board we suggest to solder a pin header strip to the 14 (or 16) pin count connector of the LCD screen.
To wire your LCD screen to your board, connect the following pins:

  • LCD VSS pin to Arduino GND
  • LCD VDD pin to Arduino 5V
  • LCD RS pin to digital pin 12
  • LCD RW pin to Arduino GND
  • LCD Enable pin to digital pin 11
  • LCD D4 pin to digital pin 5
  • LCD D5 pin to digital pin 4
  • LCD D6 pin to digital pin 3
  • LCD D7 pin to digital pin 2
  • Additionally, wire a 10k pot to +5V and GND, with it’s wiper (output) to LCD screens VO pin (pin3). A 220 ohm resistor is used to power the backlight of the display, usually on pin 15 (A+) and 16 (K-) of the LCD connector.

The process of controlling the display involves putting the data that form the image of what you want to display into the data registers, then putting instructions in the instruction register. The LiquidCrystal Library simplifies this for you so you don’t need to know the low-level instructions.
The LiquidCrystal library allows you to control LCD displays that are compatible.

arduino-lcd-display

Reference: https://www.arduino.cc/en/Tutorial/HelloWorld

shares

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close