Stepper Motor Control with Potentiometer

This tutorial is all about tuning the speed of a stepper motor using a potentiometer. The idea is to up or down the speed of a stepper motor using with analog read. Theoretically analog input to a digital output, we’re going to use this concept to control the speed of a running stepper motor.

The Stepper motor used here is a rusty old EPOCH (5 wires) stepper motor, which is a unipolar stepper.

Use the analog input with the help potentiometer to control the delay in-between each steps of the stepper motor. Shorter the delay in-between each steps – faster the stepper motor runs and vice-versa.

Arduino Compatible SCM & DIY Kits
Electronics Equipments & Tools
Module Board For Arduino

78,251 views
306   

step_L293D_potentiometer

shares

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close